Arduino Pro Micro ATMEGA32U4

Arduino Pro Micro ATMEGA32U4 Micro Usb

5V 16 Mhz Atmel Arduino Development Board Electronic Circuit  Project Development Kit

The product comes without a program. Read the explanations at the bottom for use.

     Arduino pro micro is made with the ATmega32U4 integrated circuit. It comes with a Microusb socket. Thanks to the usb hardware on the processor, the connection is established directly over usb. There is no need for a usb converter on the board. It can be programmed with the Arduino ide.
 

Features:

• ATmega32U4
• It can be programmed on the Arduino IDE.
• Micro usb connection socket.
• It takes its power from the usb port.
• Operating voltage: 5V
• Speed: 16Mhz
• Flash Memory: 32 KB
• SRAM: 2 KB
• EEPROM: 1 KB
• 9 Channel 10 bit Adc
• 12 io pins
• Pwm support on 5 of the IO pins
• Uart serial communication port
• RX TX indicator led
• 1 Pcs power led
• Dimensions: 33mm x 18mm
• Weight: 4gr

Use: When you connect it to the pc, the hardware is not detected. When you short circuit the reset and gnd pins with a 10kohm resistor or a tweezer, a short-lived com port is created. You need to set the com port number as the com number in the arduino. The com port disappears after a short time. 

Select “Arduino micro” as the board in the arduino. Select one of the examples, for example led blinky. Start the compiling and uploading process of the program. When the compiling is finished and the uploading texts appear, short circuit the Reset pin and gnd again. Exactly at this moment the uploading will connect. After the uploading, when you connect it to the pc it will now appear as Arduino micro and you can continue using it normally. You will no longer need to do this operation again.

Package contents:

• 1 Pcs Atmega32u4 Pro Micro
• 2 Pcs 12 Pin Male Header

Note: there is no cable included with the product. If you do not have a micto usb cable, do not forget to obtain one.