- Stok Durumu: Stok Var
- Marka: OEM
- SKU: RBZ.101.145
DC 12V 36V 15A 500W Brushless Motor Driver
Pwm Bldc Control Board JYQD-V7.3E2 120 Degree Hall Balanced Adjustable Speed Automobile Vehicle
The mosfets under the product must be mounted on a cooling surface. If proper cooling is not done, the mosfets will be damaged. It can be used with a fan up to 100w. Above 100w you need to use it with cooling systems suitable for the power.
It is a 500w brushless motor driver board. It is used with 120 degree brushless motors. The motor speed can be adjusted between %0/100 with a potentiometer. There are motor detection sensor inputs. It has on off control button support. It has a speed signal pulse output. The motor direction can be controlled with a switch.
The case and the cooler are not included with it. A cooler must be used according to the instructions in the descriptions. Its small structure is suitable for use in your projects.
Features:
- Model: JYQD V7.3E2
- Supply voltage: DC 12V / 36V
- Operating current: 15A ( Maximum16A )
- Motor power: Maximum 500W ( Above 100w the use of a suitable cooler is mandatory. )
- Pwm frequency: 1-20Khz
- Duty setting: % 0/100
- Speed adjustment pot input
- Board on off switch input
- Direction control switch input
- Overcurrent protection
- Stall protection
- Color: Green
- Material: Various electronic materials / Pcb
- Operating temperature: -20C / +85C
- 5 Pin 3.96mm motor connection socket.
- 6 Pin 2.54mm control pin
- 5 Pin 2.54mm motor hall detection connection socket.
- 4 Pieces 3mm mounting hole
- Dimensions: 42.5mm x 63mm
- Weight: 27gr
Warnings:
- Check the suitability of the voltage and power parameters of the motor. If you connect a motor that can be damaged when high power is transferred, your motor may be damaged.
- It is used with 120 degree brushless motors. You can adjust the motor 3 phase hall order according to the actual situation. Thus you can reach the most efficient driving condition.
- Its case and cooler are not sent with it. It can be used with a fan up to 100w. Above 100w the use of a cooler is mandatory.
- It is mandatory that the 5V output on the board is not connected to any other external circuit. It can only be used for the speed adjustment pot and enable switch connection.
- The motor cables must be shielded. They must not be longer than 50cm. Otherwise the motor rotation is affected in a bad way.
Control Port:
- Z/F: It is the rotation direction control pin. 5V connection or leaving it empty is the “forward” direction. 0V runs it in the “reverse” direction.
- VR: Speed control pin. Analog speed adjustment input pin. A voltage between 0-5V must be applied. A 20kohm potentiometer can be used.
- El (Enable): On off control pin. It does not work at ground connection. The board works at 5V or floating.
- Signal: Speed signal pulse output
- GND: Ground
- 5V: 5V supply output for control signals
Power Port:
- MA: Motor A Phase connection
- MB: Motor B Phase connection
- MC: Motor C Phase connection
- P- : Gnd ground connection
- P- : Supply connection
Package Contents:
- 1 Piece JYQD V7.3E2 Motor Driver
.
