PCA9685 I2C 16 Channel 12 Bit PWM Controller Board

PCA9685 I2C 16 Channel Programmable 12 Bit PWM Signal Generator Board

Servo Motor Driver Circuit Module IIC Robot Arm Arduino Raspberry Pi 1.6kHz

     Thanks to this board you can add an extra 16 PWM outputs to your Arduino or other microcontrollers. It can be used in 16 channel led or servo motor driving applications. It provides 16 adjustable pwm output controls over 2 Pin serial communication. It has 12 Bit resolution. It can operate with DC 3.3V and 5V supply voltage. It has 3 Pin male motor connection output sockets. These sockets are suitable for connecting standard servo motor cables. This way servo motors can easily be plugged into and removed from the board directly.

     Thanks to the connection pins found on both ends of the board, it has a structure that can be attached to one another. Thanks to the terminal block connection on it, you can apply external supply from the V+ line. Reverse voltage protection is available. There is no need to drive the board continuously. With the 25 mhz crystal on the board it produces the output signals without interruption. It can continue doing this job for days.

     Important Note: On some board versions of this product, the V+ supply given over the terminal block is not directly connected to the servo motor outputs. For this reason the servo motors may not work despite power being given to the terminal block. In this use, the servo supply must additionally be given from the V+ line on the 6 pin header at the edge. If desired, by making an external connection between the terminal block V+ line and the servo motor V+ line, use with a single supply can be provided.

Features:

• Supply voltage: DC 3V – 5V
• Programmable 16 channel output
• 220 ohm series resistor for protection and driving leds
• 25mA pin drive current
• Push-pull or open-drain output options
• I2C communication interface. ( 10K pull up resistors )
• Solderable 6 address selection connections.  I2C Addres 0x60 / 0x80
• Function to turn all outputs on and off thanks to the Output Enable pin
• Precision: 12 bit 4096 Steps
• Frequency:40-1600Hz
• Adjustable pwm frequency 24Hz / 1526Hz
• Duty cycle: Adjustable 0% to 100%.
• 12-bit resolution for each output , 60Hz refresh rate for servo
• 25 Mhz crystal
• External clock signal input 50Mhz
• Low power consumption
• Terminal block socket for power input
• Reverse current protection for input pins
• Power indicator led
• 254mm 100mil pin pitch
• Board design that can be attached to one another
• Color: Blue
• Dimensions: 62.5 mm x 25.4 mm x 3 mm
• Weight: 10gr

Pin Description:

• GND:   0V Supply - pin
• OE:     Output control pin
• SCL:    I2C Clock
• SDA:    I2C Data
• VCC:    DC 5V Supply + pin
• V+:     External supply pin

Package Contents:

•    1  Piece PCA9685 Module